Help Please HOW TO? Install Boost Controller

[Moe.Moe]

Apexi Super AVCR Electronic Boost Controller


Anyone have this in there MSP.. I am buying it today but I need to know how you install it... Anyine have the HOW TO ?

[Knox Joe]

Should be fairly simple.

Tap the vacuum line to the wastegate actuator, put the boost control module there, tap a vacuum source for the third vacuum input on the module, usually on the top of the module, then wire the module to the controller.

[Moe.Moe]

Yea I know that part.. But this has to I think tap into the ECU.. Because you can do things such for Ex. Boost control in a specific gear...1st gear 9PSI 2nd Gear 11 PSI... Thats why I'm switching over from the manual Turbo XS one I currently have... Well that and its electronic..

[Knox Joe]

Ah, did not know that. Never hooked up one that is able to do that.

Good luck with that. I'd imagine it's just like anything else. Find out what wire you need to tap from the BCs instruction, then go by the MSP ECU pin out, figure out what wire you need, and hook it up.

[Moe.Moe]

help bump

[Moe.Moe]

bump

[orng1]

Wait I was aboutt to ask if you were serious but you may have some super over complicated "state of the art" boost controler. What do you have?

[Moe.Moe]

Bump help someone has to have this setup in the MSP..They used this setup in turbo magazines setup build on there Silver msp...?????????

[orng1]

It just needs a power source when the key is on and a boost source to the wastegate actuator.