MAM Manifold Question....

[dave45090]

Not sure if this is the best place to ask this question.

Can someone tell me the Tube diameter used on the old MAM manifolds?

[dave45090]

(bump)

Forcefed, Sandspeed, Rich, yellowmsp035....anyone else that owns one mind checking?

[KrayzieFox]

Off topic.. but congratulations!!

[dave45090]

Awe....somebody noticed. Thanks my man! 1,000 post and it only took me 3 years.

[Blackrose]

I would go look at mine but its too cold out. Think its an inch and a quarter. Dont remember now.

[zuku26]

Off topic again...
Any pics of your MAM hardpipes on the clocked turbo, just shots of the hot pipe will do. I'm hoping to clock mine soon as well.

[Blackrose]

No pictures but you live near me. You could always check out my setup.

[zuku26]

No pictures but you live near me. You could always check out my setup.

Are you running a clocked turbo as well?? That questions was to the OP. But if your clocked I'd rather see what you did in person.

[dave45090]

The turbo I bought was for Nissan. I clocked mine to mimic the Mazdaspeed setup. If I make this manifold I'll have to re-clock it to run the hot pipe toward the ground.....at least that's what I think.

[Blackrose]

I am clocked but also Im running a GT30/40r. My hot pipe points straight down to the ground.


Are you running a clocked turbo as well?? That questions was to the OP. But if your clocked I'd rather see what you did in person.