Power Liftgate CX9 2008 problem

[MNMAN]

The power liftgate open/close manually very smooth, however automatically it doesn't fully close, it closes 99% then beeps and stops, little push does the job.
No obstruction, I checked carefully.
I noticed that it happens only if the car is parked for few hours, but a few minutes after turning the engine on the liftgate works just fine. I checked the battery and it looks fine!!
Any idea what is the problem and how to solve it?

[DSherwood]

besides looking at the rubber seal perimeter, it sounds like the strike plate is not aligning 100%. Like a car door, it should be adjustable, make sure if your going to take on that challenge that you have the right size socket/ driver, those are large fasteners. I will look at mine later today. hope that helps.

[MNMAN]

DSherwood, thanks for your reply.

I took the car to the dealer, after acting mad :) and serious complaint the technician tried it many times and it was working fine, so embarrassing. I left and few hours later the same problem. Again the next day I went to the dealer and again it was working fine.
I was so upset and insisted that the technician check it, I have a scheduled appointment tomorrow, however it’s working fine since last Thursday.
I shall let you know what the problem was!

[weose33]

Having finally got to sleep at most 7.00am due to the noise of neighbours operative along the chalet landings & chalets around us having parties until then, we eventually aware at 2.00pm perception out of the chalet window it would appear EQ2 plat (http://www.ugamegold.com/c_EQ2-Sale/) we are one of the premier to watchful as there is an spooky Sunday morn silence in the air.

[CX9 SportOwner]

Actually have the battery and the liftgate circuit tested. Probably not, but couldn't hurt since it works normally after starting and/or driving the car