MS3Zoom24
10-29-2008, 09:11 PM
So i was putting on my New COBB RSB and everything was going good. It was a little tight getting the second endlink through, but after a lil nudge it went through. so i started putting it all back together thinking it was all nice and easy 20 minute install. then i go to put the last nut on the driverside endlink and it would not thread more than half of the nut. It turns out when i gave that nudge to get the endlink through the SB it messed up the thread of the bolt.
Like all good laid plans of mice and men!!!
Like all good laid plans of mice and men!!!