Equinox
08-17-2008, 12:31 AM
Hey everyone, been forever since I've been able to say anything on this board. I recently arrived back in country, and the first thing I did was put on my PG Manifold, TRZ dogbone motor mount, AEM wide band afr, and painted my valve cover while it was off!
I will post installed pictures tomorrow afternoon, but I figured I'd share a little late night fun of my valve cover as it dries. I did this to my Protege5-T previously and I liked how it turned out. I know on the MS3s you really can't see the valve cover, but I figured, hey, why not.
Also, just for fun, I took a picture of the man cave! Note the blatant abuse of the plotter printer with the poster sized MS3 motor image. <3
I will post installed pictures tomorrow afternoon, but I figured I'd share a little late night fun of my valve cover as it dries. I did this to my Protege5-T previously and I liked how it turned out. I know on the MS3s you really can't see the valve cover, but I figured, hey, why not.
Also, just for fun, I took a picture of the man cave! Note the blatant abuse of the plotter printer with the poster sized MS3 motor image. <3