how to bleed fuel system?

[starscream2k1]

Heya anyone here know how to bleed th fuel system on the msp. Just did the 626 intake manifold swap and installed new 440cc injectors.

manual says to short the the fuel pump on the DLC.. WTF is the DLC connector?

Anyone know how to bleed the system?

[Fudgie]

Just start it up and you'll be fine. Be sure to check for leaks.

[solo.]

Start it up!

That's what I did after I installed my 440cc's.

[magnumP5]

I just did this (not install 440s but primed the fuel system) - it isn't really needed but it's the method the FSM explains to check for fuel leaks. I assume you have th FSM because you know of this so I don't have to tell you which pin to stick a wire into but the DLC is a little black box-looking thing with a cover that's right above the front driver's side strut mount in the engine bay, right near the edge of the hood. Take a piece of wire about 4 inches line, strip both ends and put one end into the DLC and attached the other one (through some means) to the ground point that's attached to the strut mount. Make sense?