SLS midpipe studs

[br289165]

I'm going to bolt the SLS catless midpipe to an OBX header. The SLS has no studs on it. Do I get the studs off the old catted stock midpipe? Also which end of the SLS pipe bolts to the header, it didn't come with instructions. I'm trying to get all of this straight before I start taking it apart.

[NCZ13]

no youll have to use all new hardware.

you could make your own set from grade 8 pieces (2 long screws, a bunch of washers, and the matching nut for the screw.

or you can get the hardware from your local mazda parts department.

the stock hardware screw is welded to the midpipe.

youll have to reuse the washer and spring however from the stock stuff

[aMaff]

Bolt != screw...

But yes, get some grade 8 hardware from lowes or home despot and make your own. 2 bolts, 2 nuts (hah), 4 washers.

[NCZ13]

sorry i just woke up, i couldnt remember the word bolt, and it was on the tip of my tongue.

i felt stupid writing screw

[aMaff]

haha fair enough. On a side note, sounds like another quality product from SLS...(yupnope)