PDA

View Full Version : HID kit blowing my fog fuse....


LReyes66
07-06-2008, 01:24 AM
Ok well i got my new slim ddm hid kit in the small as well as my 9006 3k yellow bulbs...

soo i moved my old bulky hid kit to bottom to use for my fogs and used the new ddm 6k hid kit for my low beams.

I took out the old h7 bulb from the old kit and but it on the 9006 3k kit.

The ddm worked great for the low beams but when i connected the HID kit for the fog lights using the battery harness that was included in the new kit and turned on the fogs it didnt work. I checked the fuse in the engine compartment and it was blown... soo to test it out i moved the horn fuse to the fog fuse and that also got blown... im about to head out to buy some more fuses... anyone know whats wrong?


Oh when i was connecting 1 HID fog... it worked but when i connected the 2nd one it blew the fuse.
Super Unique
07-06-2008, 01:55 AM
crappy aftermarket ballast. use a relay for the ballast off the battery and the stock fog switch as the switching signal.

if a little lightbulb didnt just go off for you in your mind, DONT try this on your own :)
LReyes66
07-06-2008, 02:03 AM
i did use a relay harness :(
Super Unique
07-06-2008, 02:04 AM
bad kit?
LReyes66
07-06-2008, 02:17 AM
the kit was working perfectly for my low beams.. but i decided to use them as fogs and use the new DDM slim Kit i bought for the low beams soo the engine bay looks cleaner
Super Unique
07-06-2008, 02:19 AM
sounds like the relay has something wrong with it....
LReyes66
07-06-2008, 02:22 AM
well it has a fuse connector on it... do i take that fuse out or something O_o
Super Unique
07-06-2008, 02:24 AM
removing fuses is a bad, bad idea. They are there for when something goes wrong, which in your case , something is going wrong.
LReyes66
07-06-2008, 02:34 AM
what does it mean when the fog fuse 15amp one in the engine compartment fuse mean when it blows?!? to much power for it to handle?!
Super Unique
07-06-2008, 07:32 AM
when a fuse blows, whatever you were running off it is drawing too much current.
laserblueP5
07-15-2008, 12:22 AM
try running a 25amp Fuse, your kit takes about 20 amps of power you will need to check wiring before doing this to check if there is no exposed or damaged wiring.

P.S.: If You Are Not Sure Go To a Local BestBuy They Will Be able to find the problem.
iredremix
07-16-2008, 09:53 AM
my fog fuse blew too and i bought a klight hid kit. i replaced the fuse and it's been fine.