PDA

View Full Version : Haltech E6X Wiring/Map/Installation Help


Metallic36
06-07-2008, 10:56 PM
Just wondering if anyone can tell me what wires will need to be connected to the ECU? I found a thread where Juan had taken a photo of his Protege-specific harness but now I can't find the thread. Anyone have the information for installing it on a Protege?

Also curious to see if anyone has a base map for a Protege. My mods are in my sig. Still running on stock fuel pump and stock injectors. When the car is first started with the Haltech, what needs to be done so the coils don't get fried? Or any other precautions..
Packerfan
06-08-2008, 12:04 AM
bump
mspHtown
06-08-2008, 02:43 AM
not sure that this information is correct but this is all i could find.
Metallic36
06-09-2008, 12:34 PM
Bump.. does anyone know if the manual listed above shows all the necessary wires that need to be connected in a MSP? Just want to make sure.. Also wondering if the directions for the F10X on the Hiboost website is the same for installing an E6X?
mspHtown
06-09-2008, 04:26 PM
well the f10x is fuel only. so there is going to be more to install on the e6x for sure.
Metallic36
06-09-2008, 09:00 PM
Is there anyone out there that knows what additional wires will be used? *sigh* I read in a post by Juan that not all wires are used, so I wanna make sure I do this right.



well the f10x is fuel only. so there is going to be more to install on the e6x for sure.