ProScan OBD-II Scan Tool software

[khoney]

I ordered the scanner with software over a month ago, and have been trying to play around with it occasionally. I would not suggest that anyone purchase this for the Maxda 3 or MS3. Half of the parameters don't work, the display update rate is ridiculously slow, and the HP/Torque plot doesn't work. I'm not sure why this stuff doesn't work, since OBD-II is a standard protocol, and the PIDs that this tool reads are the same for every vehicle.

I'm writing my own program to access the ELM327 scanner, and I have no problem with reading all of the parameters and graphing them. Not sure why the supplied software sucks ass. Buyer beware...

[khoney]

More info on what's wrong. The PID list is divided into three sections - 1H-20H, 21H-40H, and 41H-60H. The scanner is getting the responses from all reported PIDs (i.e. the actual 'raw' ASCII responses that are displayed in the lower-right corner of the display) are correct and updating, but the actual formatted displays/graphs are only working for PIDs 1H-20H. Definitely some type of software problem.

[GoFast]

well there you go!! i understood roughly half of that but it sounds like you know what the issues are at least!