First time on the dyno (Feedback wanted!)

[justinlansdale]

My local shop was sponsoring a dyno day at Philly Dyno Works and i decided to join up and run 4 pulls.

Mods:
-Greddy SP2 cat-back exhaust.
-Injen CAI.
-Greddy Type-S BOV (Recirculated hot pipe setup).
-Hallman MBC set @ stock boost.

The car still has both stock cats and stock SMIC with crappy plastic piping. The day before the runs, i replaced all my stock vaccuum lines with silicone lines from the WG acuater to the intake manifold, although everything is still T'd in to a single source line.

Here's the chart for my first two runs (thanks to turbolife for converting the boost from .bar to .psi!):

http://www.msprotege.com/members/turbolife/Run1and2-STDCorrected%20copy.jpg

Feedback?

[MSP_4_CODY]

not to bad but man do these cars need a tune, your droppin under the 10s, ss afc!!! and you can really make some #s!!!

[SwirlFX]

It's about right on point where it should be. Looks similar to mine.

[Jasonboy]

Do all stock MSP's dyno with that much tq ?

[TurbomanProtege]

not bad for what you got

[69RMSP]

Perfectly stock, do your car a favour an get a midpipe/smic/afc.

[low_psi]

Numbers are fine.

JNZ Tuning sponsored the event right? I saw your car in pics over at EvoM

[DiscreetSpeed]

Do all stock MSP's dyno with that much tq ?
shamefully yes. Ive seen lower .... like in the 130's. But then again dynos are different (sad2)

[DiscreetSpeed]

The car still has both stock cats and stock SMIC with crappy plastic piping.
just havent gotten to these yet huh? (glare)
lol not bad numbers thou! now free up some more exhaust.

[turbolife]

Numbers are fine.

JNZ Tuning sponsored the event right? I saw your car in pics over at EvoM

Yup


just havent gotten to these yet huh? (glare)
lol not bad numbers thou! now free up some more exhaust.

That's what I'm saying, get them damn cats off Justin!!