PDA

View Full Version : knock sensor input


kicker22705
02-11-2008, 10:32 PM
i see there are two knock sensor wires coming off the ecu. which pin is the knock sensor input? thanks.
kicker22705
02-11-2008, 11:46 PM
nvm i found it. 57 :)
SeR_Cyclops
02-12-2008, 10:18 PM
what are you trying to hook up?
kicker22705
02-12-2008, 10:26 PM
i hooked up a turboxs knock light.
SeR_Cyclops
02-12-2008, 10:48 PM
how did you do it? i was thinking about getting one cause j&s's are high
yashooa
02-12-2008, 10:53 PM
how did you do it? i was thinking about getting one cause j&s's are high

Yeah but the J&S actually modifies your timing and it can do a lot more.
It can really save your ass if you step over the line.
kicker22705
02-12-2008, 10:59 PM
once i figured out which wires to tap into it was quite easy. there are just 4 wire to tap...

Acc. On Power
Ground
Knock Sensor... Pin 57
RPM... Pin 48

Once that is hooked up, you calibrate it, adjust the sensitivity, and thats it.
kicker22705
02-12-2008, 11:03 PM
Yeah but the J&S actually modifies your timing and it can do a lot more.
It can really save your ass if you step over the line.

You can bet i will be buying one once the new ones are available. i heard the new ones are supposed to have headphone jacks now which is gonna be very sweet.

the turboxs is getting me by until it is released, which i last heard was not for another 3 months. fortunately the turboxs knock light has been surprisingly accurate.
SeR_Cyclops
02-12-2008, 11:06 PM
its just if i spent the 600 bucks to get the j&s its still hard to hook up.
Maxx Mazda
06-16-2008, 04:44 PM
What sensitivity do you have your TurboXS set at? I'm trying to dial mine in.