View Full Version : Reverse signal/speed sensor wires?
Rally Ninja
02-01-2008, 09:06 PM
I'm trying to install a Pioneer AVIC-D3 and need to figure out where these wires are.
Also I have my car hooked up to a unichip. Would I tap into the unichip or ECU speed sensor wire?
(I'm guessing its at the ECU?)
Rally Ninja
02-03-2008, 04:41 AM
Ok I found out its at the ECU.....Green/red wire.
Pleaseeeeeeeeeeeeeeeeeee where is the reverse signal? Can it be by the shifter?
Rally Ninja
02-04-2008, 11:43 AM
Well thanks for nothing..
Had to dig in 3 different forums but I think I found it
VSS is Green/red stripe on ECU 58pin
Reverse light.....................just ended up hooking it to the reverse light wire all the way at the back of the car. =(
Hope this helps someone else in the future.
MikeBlueP5
02-15-2008, 08:56 PM
when hooking up the d3 do you need + wires or - wires. the reverse switch could also be located on the transmission, there should be a sensor on there. i just ordered a d3 and i was looking for the same two wires, but trying to find them other than at the ecu, they should be under the dash somewhere before the ecu
Rally Ninja
02-16-2008, 01:08 AM
I hooked it up to the + wire. Haven't had any issues so far.
Powered by vBulletin® Version 4.1.7 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.