DG Carbon Fiber shift plate

[K. Soze]

Well, I just installed it tonight. It's looking pretty good.

Thoughts: What a PITA to install. It took a lot of sanding and test fitting to get to fit right. Did other members who have installed this have this type of experience? BTW, it's the one-piece version.

[Pirana]

Yeap, I used a die-grinder and a sanding drum to it. Best way, but you have to be careful not to over do it. Good job, at least you didnt just jam it in there.

[K. Soze]

Hells no, B.

I did my homework before I purchased it. I kind of knew what I was getting myself into. It fits in there very snug now. I think I could've probably taken a little more off all the sides but it still fits well now.