Boost Gauge Install Question

[SpeedThree2K7]

I will be installing my Prosport Premium Boost Gauge on my '07 MS3 soon. I would like it to be white during the day and amber at night. does anyone know the proper wires to tap into for this install? Thanks in advance.

[meha11]

since nobody has helped you yet i will, if you post the instructions for me to read.
Also, are you putting this by the steering wheel or on the center dash?-

[~JoJo~]

you can tape the orange wire in the (DSC) switch. Mine is done so when I turn the light on, the gauge lights up.

[SpeedThree2K7]

since nobody has helped you yet i will, if you post the instructions for me to read.
Also, are you putting this by the steering wheel or on the center dash?-

Thanks, I got my info elsewhere. I was mostly curious of where to find the wires in my Speed3 that I need to tap into. Thanks though! I appreciate someone finally replying!

[sanscritt]

Thanks, I got my info elsewhere. I was mostly curious of where to find the wires in my Speed3 that I need to tap into. Thanks though! I appreciate someone finally replying!


Can you tell me where you got your information?

Thanks,
Jerry

[clos561]

i had a wire diagram i wrote down for the car, the wires, colors with descriptions, ill look for it and post if i find...i have aftermarket radio so tapping into the wires was alot easier

[Powerslave]

if you get an add a cicuit from autozone you can just use the fuse box

[fragchild]

Using Add a circuits
I used "cigar" for power (red wire),
"IG SIG" for White Illumination (white wire)
"Tail L" for Amber Illumination when the I turn the lights on. (green or orange wire? I can't remember)