what are you thoughts on these rims - ms6

[bova80]

This is just a photoshop but this is what i am thinking of getting this spring for my summer wheel.

18" Enkei Rs7 - 19.5lbs
http://users.adelphia.net/~bova80/wheelphotoshop.jpg

close up
http://www.edgeracing.com/images/wheel/enkei_wheel_rs7_(silver)_angle_zoom.jpg

[bigj884]

probably look better dropped, but i like them....maybe in gold? or black with polished lip?

[bova80]

how about this
http://users.adelphia.net/~bova80/rs7black.jpg

http://www.edgeracing.com/images/wheel/enkei_wheel_rs7_(anthracite)_front_zoom.jpg

[fourthmeal]

What are the offsets you guys have to deal with in the MS6, and what is the widths?

[bigj884]

black looks good to.....anything in gold?

[Parad0x01]

I say if u go black get ur stock rims powder coated satin black. They look amazing

[bova80]

well no i want to use my stock rims for the winter and these for the summer.

[zoomzone]

What are the offsets you guys have to deal with in the MS6, and what is the widths?


offsets depends on the width on the 6. If you stick with a 7' wide rim, the 42mm+ should be fine. If you go 8", then a 45-50 mm will be needed, and will fill out the edges of the wheel well to the point that it borders on being too wide.

Generally speaking, an 18x7 43mm offset will be a good fit.

This has been my experience. If anyone has better info, I'm all ears(hear ya)

[fourthmeal]

Sounds like the MS3 mechanically, then. The RX8 wheels tend to fit like they belong there, even though they are 18x8 and all.

A fellow MS3 installed WEDSPORT 18x8.5!! and they fit, which blew me away. The clearances involved in that were so tight, I doubt you could get much closer.

BTW, that was a beautiful fit, too.

[amp]

never been a fan of wheels that have additional holes in em...

[bova80]

they have caps that can solve that problem.