Rear brake replacement?

[Rimbo]

Is there something special you need to do to push the piston in on the rear brake assembly? I tried a c-clamp but don't want to force it. I allready replaced the front pads and they went in with no problem.

[patmaz]

at the back of the caliper,remove the 14mm bolt,and then in the hole,there s a alen key 6mm that you unscrew to pull the piston back in...

you use the same bolt to adjust the rear brakes properly.....

[CTt3P5]

x2 Be sure to tighten it hand tight then back off 1/4 turn. After that make sure everything spins freely. If so, put it all back together and you are good to go.