Removing the MAZDA 3 from the truck [Archive]

View Full Version : Removing the MAZDA 3 from the truck

racenut

10-22-2007, 07:38 AM

HI, I just got an 08 i Touring with the 2.0. Is the MAZDA 3 lettering on the trunk just stuck on or is there holes behind it?
THANKS
racenut

mazdaspeedfreek

10-22-2007, 07:50 AM

There wasnt on the speed 6 just heat it up and then use some string or fishing line and pull it off.

racenut

10-22-2007, 07:52 AM

Thanks!!!

ZooMIN3

10-22-2007, 10:36 AM

or just pull it off with your fingernails. worked for me. didn't need any of the high speed low drag fishing line, or string or hair dryer or lubricant.

SuperStretch18

10-22-2007, 10:46 AM

If you get any left over glue, just wet it with some water and rub it off with your finger.

andrew.savage

10-22-2007, 11:57 AM

ok, before you do this, i have an '06 and i took this off to get rid of the "3" and just leave the mazda part. And it was a good thing i did because there were two pegs in it to make sure that it was stuck on correctly. As well, i would not suggest using your hands. Use fishing line and a hair dryer. It works a lot better.

racenut

10-22-2007, 12:10 PM

THANKS for all your help!!!!(rockon)