Wagner Shorty Header (Rewelded)

[Tanginamo425]

I originally put this up for sale in the NW fourms, but I figure I open it up t everyone else.

http://www.mazdas247.com/forum/showthread.php?t=123682696

[CulRidr]

asking price?
Just as a reference, most have sold in the 100-120+shipping range (I bought mine in May for 120USD shipped, although mine needed some rewelding).

Bump for a great product :D

[Tanginamo425]

Hahaha sorry about that, I'll let it go for 100+shipping. Yes I did test it out before I put it on here. Ran it for about 10,000miles and it is still good. You can use a dremell tool to clean up those welds. I just got a little to excited and put them on without cleaning it up... haha

[CulRidr]

I just realized yours is mild steel vs SS like mine, but at 100 shipped for a welded piece, this is a good deal for anyone...
I feel it pull harder, especially in the higher RPM where it normally dies off due to the shitty design of the stock manifold...

[carter1551]

this is the one that will pass smog in ca right?

[CulRidr]

You could fail a visual inspection if you don't fabricate someway of putting the stock heatshield over it, but it would pass stock emissions no problem since you are retaining both cats.

[carter1551]

oh man now i want this thing

[Tanginamo425]

oh man now i want this thing
Agreed, there was a noticeable pull from low to mid. I just wish I was still in school to dyno it and see the differences. Anyway it just bolts right up to the first cat. PM me if you are interested

[jomoyo069]

i know they dont sell them anymore but just curious where did u buy it from?

[Tanginamo425]

sale pending....

[spd_dvl]

sorry to thread jack but what happened to wagner?

[theice]

I may have one of these up for sale soon. It actually needs the welds fixed, which I was gonna have done before selling.

Anywho, let me know if you're interested as is.

[Tanginamo425]

sold