CanMP5
05-27-2007, 07:41 PM
Just wanted to thank you for the good service the header and exhaust work perfect together. Though there were some fitment issues with the OBX, where the header tends to push the exhaust pipe back, making the mid-pipe flange touch the oilpan. I fixed the problem with the grinder, and all fits perfectly. I definitely recommend the combination to any N/A application and your store as well.
Below are the pics:
- The OBX header was cermic coated by Fireball headers in Erin, Ontario. Looks good but the application could've been better since primary 1 and 4 have areas of only thin coating resulting in slight chipping (after a week of driving), everywhere else is great and I hope it holds up. Engine bay temps are way down though, especially when I open the hood. In a few minutes I can actually touch the header.
- The RB catback was just recently installed and it sounds amazing with the header, perfectly mellow in sound but loud enough when wanted. The s-pipe has started to get that nice purpling (don't know if you can see it in the pic)
Once again thanks...
Below are the pics:
- The OBX header was cermic coated by Fireball headers in Erin, Ontario. Looks good but the application could've been better since primary 1 and 4 have areas of only thin coating resulting in slight chipping (after a week of driving), everywhere else is great and I hope it holds up. Engine bay temps are way down though, especially when I open the hood. In a few minutes I can actually touch the header.
- The RB catback was just recently installed and it sounds amazing with the header, perfectly mellow in sound but loud enough when wanted. The s-pipe has started to get that nice purpling (don't know if you can see it in the pic)
Once again thanks...