Corksport s pipe

[GhostMercury]

did corksport stop making the s pipe? i tried searching the site for it and i couldn't find it

[JCell]

it was on backorder but should be available now

it's a great piece, i have it sitting in my room waiting for my turbo install

[Velocifero]

just a warning, i am in no way slandering corksport, if you get this pipe, make sure you have all motor mounts and a flex pipe in the exhaust. I had the pipe on for about three months and it sheared in half, I have filled front, and side mounts and they keep the wheel hop to a null, and I don't launch my car anyways, also have a big 3" flex section in my Vibrant exhaust. I wasn't the only person to have theirs shear either, some even had AWR mounts. From what I could tell looking at the piece after the break is they didn't use enough material or heat. They replaced it with proof of the mounts and flexpipe, but honestly the install and uninstall sucked enough as is so I sold it when I got the new one. that isn't the only welding problems they have had, I have three friends, 2 msps and a p5 that had their CS exhaust fall apart. I hope they have found a better welder. their customer service is very good and I still recommend them, I just am a little hesitant to buy anything they make in house. IMHO your best bet if you can have any downtime is to send your calloway spipe to extrude hone for a better flowing replacement, it will cost you the same.

[orng1]

I also broke my S pipe in half, looks like the weight of the exhaust and the vibration just broke it in half. I only had it on for a few days before I noticed a leak, maybe even less.

[fr0st]

just to make this funny, i find it ironic they call an s-pipe which is supposed to be less restrictive "cork" :P


jk

[Lodivigo]

IMHO your best bet if you can have any downtime is to send your calloway spipe to extrude hone for a better flowing replacement, it will cost you the same.


You wouldn't happen to know the inner or outer diameter of the stock s-pipe would you?

[Velocifero]

You wouldn't happen to know the inner or outer diameter of the stock s-pipe would you?
off the top of my head, but I can find out with a little time to sit, right now i am mostly post and go, but tomorrow I'll have some free time hopefully.

[69RMSP]

I bought Velocifero S-Pipe :)

Regarding what Velocifero was saying. F/r Motor mounts are a moust and a flex pipe right after the J pipe is also a must.

But its all worth it in the end trust me :)

[tricky]

did corksport stop making the s pipe? i tried searching the site for it and i couldn't find it
try this:click here (http://corksport.com/store/category/66ax/MSP.html)

[Lodivigo]

off the top of my head, but I can find out with a little time to sit, right now i am mostly post and go, but tomorrow I'll have some free time hopefully.

Cool, if you have one laying around then the info is much appreciated. If not then don't worry, I'm just being lazy and don't want to get under my car to look :D

Edit: Got the dimensions, nvm.