getting a EBC

[Myspeed12]

If i get a EBC would I still need a boost gauge, i was wondering if an EBC tells you what PSI your running.

[Myspeed12]

bump

[jestermsp]

sure do. i dont know a single ebc that reads in psi. unless u get the aem tru boost. its a gauge n controller all in one.

[Myspeed12]

So a Greddy Profec B II would elminate the gauges? Would I need the gauges to know my psi?

[jestermsp]

the greddy does not read boost. you have to calculate percentages to get the proper boost setting. and the only way to read that setting is with a good boost gauge.

[funktownp5]

The greddy profec B2 reads vaccum and boost, it also gives u peak boost

numbers as well(bar instead of psi). But i wouldnt use it as a boost guage

though.

[geomatics_tech]

My Greddy Profec b Spec 2 read 5.5 psi on stock settings, this number seemed reasonable to me so I use it for my boost gauge. I only run 8 psi, so even if it is out a psi or two Im not worried. Its a good ebc after figuring out the adjustments.

[Myspeed12]

well jetermsp said it doesnt read boost, but others say it does, I dont get it

[jomoyo069]

get the AEM one from protegegarage.. it is an ebc with a gauge.. just like jestermsp said

[smo0f]

greddy profec b2 reads boost in PSI. i have one

[Myspeed12]

I was looking at the AEM boost controller/gauge but the gauge looks like it doesnt show the psi where it is at, when I enlarge the picture it doesnt show what psi its holding. Does anybody have a picture this

[geomatics_tech]

well jetermsp said it doesnt read boost, but others say it does, I dont get it

To set the desired boost level you use a percentage of the turbo, but the output reading is available in psi and bars.