ABS and brake lights on after brake pad replaced

[BIGCU]

a while ago my ABS and brake light came on and this has happened before but that was due to my front brakes needed changing. so i changed the rear brakes but they're still on... any ideas whats wrong with them?

[BIGCU]

any help would be great!!!

[ZenProtege]

maybe try bleeding the brakes or adding more fluid. just a guess. lol, did you say your front brakes needed to be changed so you replaced the rear brakes or changing both didn't solve the problem? I wish I had more to offer. good luck

[Falango]

Check your brake fluid level.

[122 Vega]

You may have unplugged one of the ABS sensor wires also.

Brit

[ZenProtege]

^ good point

[210_ZOOM]

double check your fluid also, could be too much or not enough. GL

[BIGCU]

story is.. on a road trip one time the ABS and brake light came on... we saw the front pads were a little thin so i changed those. The light went off. months later it came on again and i heard squealing from the rears. I changed those but the brake lights has yet to turn off.

Thanks i'll double check the bake fluid see if its low.

[Falango]

If you have recently changed your pads you should check your fluid level. It will most likely be too high because at some point I hope you topped it off once it started getting low (because the pads were getting low).

[BIGCU]

brake fluid is fine... lught still on

[210_ZOOM]

maybe it has too much.

[BIGCU]

has the right amount.
where are the abs sensors?
are they on all 4 wheels?

really wanna get this fixed before the snow starts settling in
thanks guys in advance