Just bought a Microtech LTX8S

[03.5MSP]

Well I just bought a microtech ltx8s and a handcontrller for $900 off of ebay. Unfortunatly its is off of a rx7 so its not a direct swap. I found this out after i bought it. So now i will have to send the microtech back to australia to get it re-configured($350). Once that is done I also have to get the bosch coils cause the ltx8s has the igniter box built into the unit. The good thing is that i dont need a laptop to tune the ems, cause i can use the hand controller, and i can store up to 4 maps on it. I know it would of been chaper to get the lt10s then this, but i found out too late. Im not in a hurry, so once i get everything back and install some 440's along with the ems the coils the car should be badass. The only thing then holding me back would be the block.

[03.5MSP]

Just to keep you guys posted. Just bought some wrx 440's today off of ebay for like $100. They are from a 02 wrx. I guess I will keep you guys posted in this thread on everything about my microtech installs. I will be looking for some intersting ways to mount the bosch coils. All in all I will try to post my whole install and tuning in this thread. Thanks for reading

[03.5MSP]

Does anyone know if with the microtech and the bosch coils. Will I have 2 or 4 seperate coils. Will it be like these msd coils??

[sandspeed]

great....the microtech is awesome ems. boomer made just over 300hp using microtech.

[Little Beavis]

Yes, the Microtech is a very good piece of equipment. Too bad you found out too late that it was for an RX-7. nsnmotorsports.com has the newer models in stock, configured for the protege, and with maps for less than the $1250 you are going to pay (plus shipping, coils, and anything else). In the end you should be happy with the unit though, I know I am.

[03.5MSP]

Microtech and the wrx injectors came in today. After seeing all of the wires im thinking about selling it back on ebay, and getting the lt10 from NSN.

[03.5MSP]

More wiring pics and the current engine bay pic.

[yashart_mp3]

wow, that looks messy.

[vxfilmer1000]

Threadjack: Everyday I get in my MSP, I wish I had a Perrin FMIC and Tubular Manifold :(

[03.5MSP]

Well Im deciding to sell the microtech unit and hopefully get the lt10 from NSN. I dont want to deal with all of that headache.