some parts

[Kansei]

I think I found one of the parts I'm looking for but is the Left side driver or passenger side?

http://www.trademotion.com/partlocator/index.cfm?action=getLocator&siteid=214264&chapter=ARH5416&appSectionid=2295&groupid=2296&subgroupid=2320&componentid=0&make=22&model=Protege&year=2003&graphicID=5416670&callout=2&catalogid=2

I need the little bracket on the headlight that holds the bumper up tight to it, on the driver side.

I could also use the black plastic trim piece that is in front of the gauge cluster.. the one that you have to remove to remove the gauges. With it, the little foam strip that goes between it and the steering column, and the two screws to hold it in.

Oh and I need the hood lock, but I'll have to check and make sure I need the whole thing.. I know the bolt broke off that holds it to the support bar in the front and it makes my hood rattle. I see that it's like 48.24 on the site, that's not bad. I'd need the front bolt for it too.

while I'm at it I should really order any bolt/screw that is related to the front wheelwell and front bumper splash guards. Most of the plastic ones in the wheel wells are stripped, and some of the metal ones are broken because I overtorque all the time haha.

Oh and I have a nice new front grille emblem but it didn't come with any adhesive. rather than piecing together little strips and having it look all crappy is there a part number for the adhesive pad? I wish it would clip in like the rear emblems. If I just order the "grille" part, according to the diagram it comes with all the parts... just want to confirm this.

I'm getting some of my car repainted so I want to fix all the little broken things (all my fault) so that it's looking nice and fresh.

sorry about all the parts and vague descriptions and stuff haha.

[bagman1]

I think I found one of the parts I'm looking for but is the Left side driver or passenger side?

http://www.trademotion.com/partlocator/index.cfm?action=getLocator&siteid=214264&chapter=ARH5416&appSectionid=2295&groupid=2296&subgroupid=2320&componentid=0&make=22&model=Protege&year=2003&graphicID=5416670&callout=2&catalogid=2

I need the little bracket on the headlight that holds the bumper up tight to it, on the driver side.

I could also use the black plastic trim piece that is in front of the gauge cluster.. the one that you have to remove to remove the gauges. With it, the little foam strip that goes between it and the steering column, and the two screws to hold it in.

Oh and I need the hood lock, but I'll have to check and make sure I need the whole thing.. I know the bolt broke off that holds it to the support bar in the front and it makes my hood rattle. I see that it's like 48.24 on the site, that's not bad. I'd need the front bolt for it too.

while I'm at it I should really order any bolt/screw that is related to the front wheelwell and front bumper splash guards. Most of the plastic ones in the wheel wells are stripped, and some of the metal ones are broken because I overtorque all the time haha.

Oh and I have a nice new front grille emblem but it didn't come with any adhesive. rather than piecing together little strips and having it look all crappy is there a part number for the adhesive pad? I wish it would clip in like the rear emblems. If I just order the "grille" part, according to the diagram it comes with all the parts... just want to confirm this.

I'm getting some of my car repainted so I want to fix all the little broken things (all my fault) so that it's looking nice and fresh.

sorry about all the parts and vague descriptions and stuff haha.


Left is always drivers side.

little bracket on the headlight that holds the bumper up tight to it:
RT- B30D510A7A MSRP-4.70 Website-3.76
LT- B30D510B7A MSRP-4.70 Website-3.76

black plastic trim piece that is in front of the gauge cluster:
Please supply picture, because I am going to have to get either the upper column cover or the trim that goes around the meter set I can't remember which this item directly attachs to.

know the bolt broke off that holds it to the support bar in the front and it makes my hood rattle:
Bolt- 9GG600612B MSRP-.85 Website-.68

bolt/screw that is related to the front wheelwell and front bumper splash guards:
Fasteners- NA0156145 MSRP-2.25ea Website-1.80ea (Need 12 per side)
Screw's- 9CF600516B MSRP-1.75ea Website-1.40ea (need 4 per side)

If I just order the "grille" part, according to the diagram it comes with all the parts:
P5 grille- B30P50710 MSRP-150.01 website-120.01 (this is the only way I can get the mesh part of the grille). To get the tape on the emblem you have to get the emblem: Part# S41A51731A MSRP-12.95 Website-10.36

sorry about all the parts and vague descriptions and stuff haha:
It was a little like chasing down buckshot.:)

JMBaggie

[Kansei]

An order list so that I can keep tabs on it until I figure out exactly what I'm ordering:
B30D510B7A - headlight/bumper clip
9GG600612B - I need to confirm that I can buy just the bolt, if not I need the whole hood lock.
NA0156145 - Qty: 24 (fasteners are the plastic ones, right?)
9CF600516B - Qty: 8


Left is always drivers side. thanks, good to know

Please supply picture, because I am going to have to get either the upper column cover or the trim that goes around the meter set I can't remember which this item directly attachs to. It attaches to the dash, so it's the trim that goes around the meter I guess. My steering column cover is fine, I just need the piece directly in front of the gauge cluster lens.


If I just order the "grille" part, according to the diagram it comes with all the parts:
P5 grille- B30P50710 MSRP-150.01 website-120.01 (this is the only way I can get the mesh part of the grille). To get the tape on the emblem you have to get the emblem: Part# S41A51731A MSRP-12.95 Website-10.36

It was a little like chasing down buckshot.:)

JMBaggie
thanks man for all the searching. It must have kept you busy for a while at work haha. As for the grille, I would want the MSP grille with sunlight silver top strip, or a P5 grille but with the MSP/MP3 front emblem (not chrome, sorta looks like it is painted sunlight silver) and I could get the top strip painted when I get my hood/bumper painted in a week or so.

How much more is the MSP grille with that piece painted sunlight silver?

[bagman1]

An order list so that I can keep tabs on it until I figure out exactly what I'm ordering:
B30D510B7A - headlight/bumper clip
9GG600612B - I need to confirm that I can buy just the bolt, if not I need the whole hood lock.
NA0156145 - Qty: 24 (fasteners are the plastic ones, right?)
9CF600516B - Qty: 8


thanks, good to know
It attaches to the dash, so it's the trim that goes around the meter I guess. My steering column cover is fine, I just need the piece directly in front of the gauge cluster lens.


thanks man for all the searching. It must have kept you busy for a while at work haha. As for the grille, I would want the MSP grille with sunlight silver top strip, or a P5 grille but with the MSP/MP3 front emblem (not chrome, sorta looks like it is painted sunlight silver) and I could get the top strip painted when I get my hood/bumper painted in a week or so.

How much more is the MSP grille with that piece painted sunlight silver?

MSP Grille in silver:
BP7H5071067 MSRP-171.25 Website-137.00
MSP emblem (doesn't come on grille)
00008RC10 MSRP-15.00 Website-12.00

Meter hood
B25G55420A MSRP-31.85 Website-25.48

Yes the fasteners are the plastic ones.

JMBaggie

[Kansei]

my body guy was actually able to fit my car in today so she's getting painted right now. As soon as I get paid I think I'll order the new grille, emblem, fasteners, and some other stuff (probably a full gauge cluster + lens + trim piece too).

thanks for all the research, much appreciated.