PDA

View Full Version : Unichip Install Problems...Help


TitaniumMSPinAL
06-24-2006, 04:05 PM
Ok I need some help from anyone who has installed this chip in their car. It seems none of the LED lights were working on the switches. So I used a volt meter and there is no power running to the small Boost Controller harness under the hood (the two pin harness) which tells me that there is no power to these switches?? I have taken car out for a test and it acctually seems like the unit is working because no hesitation or stumbling. Does it have to do with the acessory harness not being hooked up (beacuse no were does it say what to do with it). Can anyone give me some ideas and if not I will wait till Monday and speak with Unichip.....thanks
210_ZOOM
06-24-2006, 11:37 PM
who did you buy it from, sam at *********************** can custom tune it for whatever mods you got. check out his site, got good deals.
TitaniumMSPinAL
06-26-2006, 02:44 PM
who did you buy it from, sam at *********************** can custom tune it for whatever mods you got. check out his site, got good deals.

Well that is good to know, but I need to know if anyone has run in to this problem. I have e-mailed Unichip but I would like to get some sort of answer if possible, but no one seems to be wanting to help...
BlueBeast22
06-26-2006, 03:24 PM
Most likely you got switches that are no good. You need to call unichip and talk to one of the reps there. They will send you another one free. I had a switch that was messed up and was labled wrong and they sent me another one within a few days after contacting them. I remember they told me they had a batch of switches that was shipped out and that were not working properly.
TitaniumMSPinAL
06-28-2006, 11:40 AM
Thanks Blue for the info....I e-mailed them and Josh at Unichip is hooking me up with the replacement switches so it will all be corrected soon...
MoreBoostPlease
06-28-2006, 11:44 AM
titanium, i have had the unichip for about 8 months and never ran into any issues. hopefully it is just the switches. I also have the software to program the module, so if you need help programming it, let me know. pm me if interested. good luck with it!