cosmo420
06-19-2006, 06:09 PM
I just got my BPV and in it came with 2 round spacers that goes inside how do I go about useing them or do I need them at all? I will be installing it today any help would be great.
505zoom
06-20-2006, 07:50 PM
The spacers are there so you can tighten the valve up if need be. Try it without them first, and if the valve is opening too much (or at very low boost) then add a shim. Make sure to give the valve a GOOD vaccuum signal line... make it as short as possible, and run it without any T's if possible.
PM me if you need any assistance.
Oh and just out of curiousity, where did you get your valve from?
Powered by vBulletin® Version 4.1.7 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.