Anyone with Unichip and GReddy Profec B Spec II?

[Mark94]

I'm just looking for some information as to how to set up this combination since the Unichip comes with a boost controller of its own.

I'm assuming that I do not have to run the line through the grommet into the engine bay to hook up the Unichip boost controller and I can just put some electrical tape over the Unichip boost controller connection on the harness.

My big question is how do the LED's and buttons function I'm using the GReddy boost controller since it won't be tied into the Unichip module? From what I can read, one of those leds and buttons is for the boost control and I beleive it lights up green?

I would also assume that if I have the Unichip set to map A I would have to program the Profec to stock boost of about 6.5 psi and if I am on map B I would then set the Profec to about 10 psi.

If anyone could give me some help and some other advice you may have I would appreciate it.

Mark

[low_psi]

You are correct about not having to install the boost controller box and solenoid. This just means the boost controller switch won't function.

You're getting the maps mixed up though. You can run stock boost or higher boost on either map. The switchable maps are just fuel maps, and MapB only advances timing at WOT.