View Full Version : Unichip user, please chime in and give me a hand
msfamilia
04-19-2006, 04:50 AM
Hi all,
thanks in advance for showing lights.....
I have just installed Unichip on my 03.5 with CAI, hardpipe, J-pipe back 3" open exhaust.
I have noticed that sometimes the A/F ratio would only be wondering around 13-15 when in boost at 3/4 throttle.....
Is it running too lean?
would you guys mind to share how your A/F ratio reads through out the powerband?
what should be the target A/F ratio?
DSMConvert
04-19-2006, 11:47 AM
safely tuned 11.5...aggressively tuned 12.5ish
Captain KRM P5
04-19-2006, 12:07 PM
talk to jdm sam
msfamilia
04-19-2006, 05:20 PM
thanks for the advise.
let me try to get a hold of him right now.
Professor MSP
04-19-2006, 05:45 PM
Hi all,
thanks in advance for showing lights.....
I have just installed Unichip on my 03.5 with CAI, hardpipe, J-pipe back 3" open exhaust.
I have noticed that sometimes the A/F ratio would only be wondering around 13-15 when in boost at 3/4 throttle.....
Is it running too lean?
would you guys mind to share how your A/F ratio reads through out the powerband?
what should be the target A/F ratio?
If you go here:
http://www.msprotege.com/forum/showthread.php?t=100130
you will see a summary of the results when I took my car to a dynamometer. All three pulls were in third gear, and of course, at wide open throttle. I will look at the hard copies of the data this evening to see if I can give you further details on the air-fuel ratio. Note that I had all of the modifications in my signature when the pulls were made, save the Injen CAI.
tricky
04-19-2006, 11:09 PM
Hi all,
thanks in advance for showing lights.....
I have just installed Unichip on my 03.5 with CAI, hardpipe, J-pipe back 3" open exhaust.
I have noticed that sometimes the A/F ratio would only be wondering around 13-15 when in boost at 3/4 throttle.....
Is it running too lean?
would you guys mind to share how your A/F ratio reads through out the powerband?
what should be the target A/F ratio?
post this again but do it here: UNICHIP Fourm (http://studiosp.net/unichip/viewforum.php?f=2)
just trying to help.
msfamilia
04-20-2006, 03:55 PM
thanks a lot
off I go!
Powered by vBulletin® Version 4.1.7 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.