Boost Controller

[Brooks2741]

Im sure this question pops up all the time, but, if y'all could spare me and just give me the quick answer id appreciate it. My friend bought a universal boost controller and asked me to install it. It is a fine eBay piece and came with instructions for installing it on a 92 Toyota MR2 turbo. From what I can get from the instructions, I need to find the line going from the intake side of the turbo to the wastegate. So far I can only find the oil line and a rubber line coming off from the wasegate that runs up to the top of the engine bay on the passenger side. What am I missing? It should be a simple install but not for me. Thanks very much

[terbow]

you need the wastegate signal line. and Put the Boost controller in between that line. The line will either go to the turbo or a vac source in the manifold. So just find the rubber vac line to the wastegate and cut it. thats wherer the controller goes.

[blthlt]

all you have to do is follow the line that your stock bpv (by pass valve) is hooked to and on the bottom side of the T there is a line going to your wastegate...follow the instructions and you should be set.