Amp power wire

[hurleyblink]

i have a question, alright i was wondering where you guys ran your power wire to the engine bay, like where there is already a hole in the car to do this, like could someone take a pic, cause i want to put my kicker CVR 12's in.. cause the stock system sucks..
So any help with this would be greatly appreciated, i want to try not drill any holes if possible.. cars still under warranty, i know i gotta do the one in the trunk but big deal that can be covered im doing it under the spare tire lid.

[rx7mazda]

I managed to run my wire without any cutting.

There is a hole in the engine bay near the battery, you can see wires running through the hole. Run the cable through there, take apart your fender shield under the driver front wheel and run the wire on top of that.

Then, under the dash, there are wires comming from the fender, just pop the wire plug out and run it through that hole. From there, just run the wire as you would any other car through the door panel. Hope this helps.

[hurleyblink]

I managed to run my wire without any cutting.

There is a hole in the engine bay near the battery, you can see wires running through the hole. Run the cable through there, take apart your fender shield under the driver front wheel and run the wire on top of that.

Then, under the dash, there are wires comming from the fender, just pop the wire plug out and run it through that hole. From there, just run the wire as you would any other car through the door panel. Hope this helps.
on the drivers side im assuming right, thats the side my batt is on..

[rx7mazda]

on the drivers side im assuming right, thats the side my batt is on..

Correct.