hardpipe dimensions?

[MSP#735]

does anyone happen to know the dimensions need for our IC pipes? mainly the hot/upper pipe? diameter, angles of each bend and total length? i am thinking of piecing my own together from turbohoses...thanks guys!

from searching breiefly, i found out that the diameters are: 2" (turbo outlet) and 2.5" (IC outlet) may vary for car seeing how there are a few upgrades of SMIC's, me, i have the Circuit Sports SMIC, anyone know THAT IC outlet diameter???

[msp35]

I believe the SMIC's are designed to reuse stock pipes, therefore they would be the same as your stock measurements.

[MSP#735]

thanks what about the bends and degree of the bends? as well as the lenghts?

[byohndspeed]

you can make the hot pipe out of 2 90* 2" pipes. as for the cold side, 1 90* 1 45* and some straight with another 45* than a coupler that is also a reducer..

[MSP#735]

hmm awesome, what about the length, or do i just need a reducer to connect the 2 90 degree pipes?

[byohndspeed]

you will have to cut the pipes alittle to make then fit, then weld them together. i guess you could use a coupler, never tried it that way.