- TSB Reflash problem
- AP guestion if anyone knows..
- help CEL
- ECU Relocation? Where?
- Reading Codes
- cobb
- Gauge vs OBD-II - who to believe?
- humming noise at low speeds
- ScanGauge II Xgauge Programming
- Launch Control and or anti lag
- GI: Tuning at P&L Motorsports
- How far will a mbc\map clamp take me??
- injectors
- ECU reflash at Mazda
- Where to buy MAP clamp?
- How to get rid of a P0421 CEL...?
- Check engine light over boost 1K miles!!
- No Mazda TSB ECU flash for me?!
- P0300 CEL, mazda tried to void warranty
- AFRs (Air/Fuel Ratios)...?
- fuse f69 keeps blowing
- code and stutter
- what else do i need.
- Dashhawk drain battery?
- UNICHIP Who's Interested For The MS3?...JOSH'S MS3 GOES IN FOR HARDWIRE!...
- Apexi Power Fc
- Finally ordered my DH!!!! few questions.
- Piasini Flash installed
- greddy
- new here quick Q
- Need help with AF gauge
- What Auto Parts store Pulls the Check Engine Code for you for free..?
- cobb access port question
- miss fire or something
- Swampass AccessPort software release May 9th 2008
- What are the Best Mods for the Buck?
- Threw a P0300 code tonight
- Stock diagnostics check?
- Xede Ems
- pnp harness?
- Error Code P0106
- Cobb Site Update
- How ECUs Use Closed-Loop Controls to Make Fueling Corrections v1.02
- A Brief Study Analyzing the Effects that Throttle Mapping have on the MS3 Engine...
- Cobb AP - No Dyno = Fail
- SwampAss AP - No Dyno = Fail
- ProScan OBD-II Scan Tool software
- Even NEWER reflash for the MS3?? Since the fuel pump TSB
- Cobb AP, who has them?
- Standback question (for a friend)
- AccessPORT Firmware Update for the MS3 is Available.
- PTP Map Clamp Help?
- Cobb AP+TBE+CAI+17PSI ??? Is it possible???
- Accessport Questions
- Intake manifold runner stuck closed. (bank 1)
- How lean is too lean? How much knock retard is too much?
- So how long has the Cobb AP been out now? And still no dynos?
- AP Ripoff brought to you by Street Unit !!
- Faulty O2 sensor
- Hesitation...?
- Need help deciding on an EMS.
- Whwre to connect wire for A/f guage and shift light
- My review on Cobb AP.
- CEL with CP-E CAI and synapse BOV
- Why doesn't Superchips make a tuner for the MS3.
- CEL from race pipes
- Dyno in SO CAL
- economy mode(Cobb AP)
- P2188
- incase you didn't get the memo (Cobb AP)
- map clamp help
- Anyone Looking For A Unichip For Their MS3?
- Door open light on, no doors open?
- standback tuning question
- Is tuning necessary with the following mods:
- too lean at idle cel
- Cobb AP + BOV?
- Which gauge to get??
- Refused to reflash me?
- Boost gauge and turbo timer
- Contstantly P0300, then P2188
- ECU "learning" and the COBB AP
- off idle, clutch disengage buck
- cel p0016
- Purge valve location???
- Dashhawk question
- Ecu Wtf?
- Standback users boost pressure question
- fap fap fap fap
- a/f
- Cobb AP full Throttle maps!
- Not new to tuning.. new to boost
- boost controller question
- Spark Plugs
- Dashhawk
- Dashhawk Splashscreen
- p0401
- Cobb AP "valet mode"
- fuel cut/boost cut
- My first dashhawk data
- Multiple Cylinder Missfire Help ( I KNOW THERE ARE ALOT OF THESE POSTED)
- please help.
- stage 1+ ms cai v102 dyno
- Po245 Cel
- Maybe you guys all ready know
- Has anyone with AP had a problem with...
- CEL - Bad Gas Cap???
- Wth????
- Where to buy a Cobb AP in Toronto Canada
- Anyone get a CEL about "intermittent cylinder misfire?"
- Dashawk....Cobb AP
- Diablosport Predator...
- Romraider / Tuning gurus take alook please
- Dashhawk measure boost?
- tru-boost cp-e full throttle experiance.
- iphone dynolicious.
- My new toy
- mazdaspeed CAI VS. Cobb SRI
- Cobb AP? CP-E?
- Cobb AP, 93 oct?
- Fueling/AFR Discussion - VERY LONG
- Custom Tunes for AP users now available
- DashHawk development is dead...
- Primary o2 sensor part #
- Do we need a special OBD2 scanner for our car?
- how to get rid of boost cut
- Power hick-up at 3200 rpms?
- dashhawk map sensor pid
- Where would you fit an Access Port in this mod plan?
- AP Tune VS Stock ECU
- AP Map/Mod Question
- Gettin tuned soon!!!!
- Need a tuner in Germany
- Hey guys what's the scoop on this ECU chip?
- Can Cobb AP moniter Parameter like Dashhawk
- please help what is this light?
- Installed TurboXS Fuel Cut Defender!!
- What happend to the uni?
- Need ECU!!!
- which map?
- 400 hp thread
- 103 maps
- Wire Harrness
- AFR question
- A/F question
- dynoed today then a p0234
- NEXT MOd for a NOOB
- Piasini tune/flash impressions
- Plug and Play ECU Harness
- accesport and manual boost controler
- 08 MS3 TSB relating to fuel and pump question
- Chip/Reflash Question
- should i buy..
- Well, now we know that COBB SRI's gonna take forever,
- warning light question, help needed
- New Iphone Program...Rev...
- Where do you mount your Dashhawk?
- boost gauges?
- Dyno Day Cobb AP Stage2_FMIC_CA_91Oct_v103L Results
- CEL please help HELP 08.3 MazdaSPeed 3
- quick dashhawk question
- slow my car down
- AP ???'s
- tune or no tune?
- Best price for cobb ap
- bigger injectors
- pnp standback
- Help me pick the right one!
- VA Tuners?
- Mazdaspeed3
- Data logs after adding the HKS Ignition?
- AP did'nt solve my problem =(
- Dashhawk PID List?
- Which is better? Has more features?
- Installing a Map Clamp
- Cel P0421
- Boost cut in cold weather with clamp
- DashHawk Correction factor
- turbo xs stage 3
- How many XEDE users?
- Cobb SRI + Cobb AP? Who has both?
- AP setup with Corksport FMIC
- Some Cobb AP map dynos
- Cobb AP v103 93 octane map is very impressive!
- quick jerk in 5th gear all out
- 2000 miles and 2nd CEL
- custom tune cobb access port ?
- Spark Plugs and Ignition
- End of my rope. Re: Greddy profec b spec 2
- More than one Mazdaspeed per Cobb Tuner
- 08 MS3 dynoed on 10/28/08
- Which AP map for me?
- I got a CEL with just TurboXS RP!
- Question about CEL (Bank 1 Too Lean At Idle)
- Cel P2177, P2187 Help Help
- Beta maps for Cobb Ap
- My AP V1.03 results...
- CP-E full control
- Access Port Economy Map?
- Dashhawk AFR Monitoring
- AeM ems
- Knock sensor danger zone?
- Boost cut and cold temps ?
- Cut issue..a little help please!!
- Adding AEM UEGO Wideband Support to AccessTuner Race Software
- 2009 MazdaSpeed3 Cobb AccessPORT
- noob to tuning, need some assistance!
- Wiring for Split Second VC2 map clamp
- So I have an oppertunity to be a beta 09 tester for the Cobb AP...but.....
- Adjusting SS map clamp.
- Tune needed for my mods?
- New Cobb Ap Firmware Is Out!
- Is the Dashhawk still worth getting if I get an AP?
- CEL CODES P2004 and P2009
- ??? on tuning
- TUN File for Standback MazdaSpeed3
- reprogramming
- HELP!!!!! Installing boost gauge and having problems with the radio
- No boost on dashhawk
- Anyone seen or installed a PLX OBD II gauge
- CEL Question
- Knock and Accessport
- In "Forced Induction" threads
- cobb?standback?
- ap question
- Things to look for: shopping for DH
- Am I Crazy
- Cobb Tuning will be completing custom tunes at their Plano, TX facility.
- Cobb 1.03 maps are now available
- Analyze this data log
- First CEL yippie
- Cp-e Boost Cut Elimantor Flash, Everyone Please Read
- Anyone with AP and Nano?
- AP purchased
- AP power drop
- those with AP- federal or cali
- peep my DH logs
- knock retard
- Threw some codes need help identifing
- Flex Inovations
- AP Advice
- What effect can a hybrid valve have on an AP map, if any?
- ap q
- DH Logs
- AP Logs & Questions
- cobb ap for sellers
- changine AP from cali specs to federal
- 25k Miles CEL Today :(
- access port help.
- AP V1.03 maps