- Essential Speed Headers
- Couplings/Connectors and Hump Hoses?
- Where could I get racing mazda or ractive header?
- Header and intake
- CEL Help
- Clutch popping?
- Fuel rail
- FC3S Exhaust: Single or Dual?
- Adj cam gears on a turbo
- Exhaust system choices
- Which would you prefer?
- mobil 1 15w-50
- WTB Racing Beat Axle or Cat-back
- from synthetic oil to regular motor oil
- Exhaust Pics? Please post!
- JETCHIP reprogram
- BOV for 2003.5 MSP
- MSD 6al making car stall often
- I get Free N2O (NOS)!
- OBX Mid Pipe?
- Home Brewed Race Fuel (or higher octane)
- Anyone w/ dual exhaust tips on their P5??
- Lifter Shim Size?
- Help !!need Torque Specs Quick!
- cel P0300
- has anyone tried the mp3 to p5 ecu swap?
- P5 has a Mazdaspeed exhaust???
- Oh HELL YEAH. Got the soft AWR bushings in!
- temp??
- noob question:> improving performance
- To dip or not to dip...
- Is wilwood still only big brake kit?
- Cry02 Intercooler sprayer
- Cleaning up valves/combustion chambers/cylinders+walls and head surfaces
- FS-DE Head Bolt Torque Specs
- Motor mount bushings
- Dyno with steelies?
- 1st CAT delete Testpipe?
- Best performer?
- mazdaspeed clutch
- AWR Header on Ebay
- Maybe a repost
- What exhaust elem. the second cat?
- DRUM TO DISC brake CONVERSION!!
- solid rotor or slotted rotor ?
- Spend 2,000 on nothing but performance parts!
- ATTN: RACING MAZDA quick question
- Idle Problems
- Forced Induction or N/A?
- ??? on OBX Header quality?
- Are there any polyurethane motor mount inserts?
- Over 12k Clutch replacement
- Possible problem with steering...what could cause it??
- FastBrakes upgrade?
- Satisfied Brake Pads
- caliper noob question....
- restarting ecu for new muffler
- MSP INJeN Clips?
- MIL vs Cat 02 performance?
- using toluene as an octane booster
- Heat wrapped header
- what plugs?
- Setting timing after rebuild
- FS Weak spot - thrust bearing
- Gutted 1st cat
- Chirping clutch
- the FS-DE was in the probe.........will the V6 from the GT fit in a Protege?
- Injen Cai newbie
- can you buy just a rear motor mount?
- Cam install proceedure.
- RPM's and your protege.
- has anyone ever tried this?
- Kartboy's shifter bushings??
- So I didnt buy the SPOOL car and now I have this money....
- Any mp3 owners wanna swap ECUs?
- Who has changed their Transmission Fluid?
- K&N Typhoon Intake
- Need Help!!! Stripped Nut
- Compression ratio and Forged piston
- Clutch ?
- Do someone have a S-ACF2 ?
- Crazy Mod My Friend Got...Good for MSP?
- Car running like ass (or not at all) after rebuild.
- Oil Pressure Gauge install issues. HELP!!!!
- Supercharging the FS motor...check out my newest toy!
- royal purple trany fluid
- AWR headers not in stock?
- exhaust/cat question
- Help with Clutch & Flywheel
- Auterra PDA OBD-II scan tool
- Big Hesitation Problems
- Wagner vs. Ion FMIC + CAI
- Engin in 3gen,p5,mp3,msp is it all the same ?
- Smell Question.
- Spacers?
- Spark plugs?
- No cat question
- exhaust without welding? HELP!
- Crankcase vacuum
- Decisions Decisions
- DGM Ram Air Hood
- Weight of stock block and crank???
- Amsoil Users?
- 88 2.2l performance?
- oil capacity
- Redline Mt-90 VS Mobil1 75-90
- new brake pads
- Scary!
- +4 HP for free!!!
- Intake material: SS vs. Aluminum
- looking to add some new goodies
- AWD---The wheels are turning
- Turbo Timer?
- OBD socket location?
- HELP!!! How do I get more power out of my P5?
- Injen vs. K&N Typhoon
- Is FWD really that bad?
- YEAH!!! I ordered an APEXi filter!!!
- what for rims????
- CEL w/cam install??
- E-manage question
- Trans fluid change
- F'd Tranny
- Flow numbers for 2.0 head?
- How loud are the AWR headers?
- Apexi intake setup
- How restrictive is the msp muffler?
- intake manifold and fuel rail
- Kartboy Exhaust Hangers
- i/h/e gains
- CAM Prerequisites??
- Anybody just disable VTCS?
- rotors and pads
- $$$ Pricey 02 sensors
- Anyone using larger oil filters?
- HP with just J-Spec intake cam?
- Protege5 on normal Protege
- short shifter installed
- Installed 2003.5 MSP Axle-back
- Maybe a dumb question about Exhaust and HP.
- joe p. fpr and fcd
- Tire wear! 3rd set w/ only 23k miles
- MS exhaust vs P5 sport exhaust
- K&N Air Filters
- Which one is it?
- Rebuild
- Ground Wires Revisited
- K&N for an Injen CAI
- Anyone running the Racing Beat cat back & AWR Headers?
- anybody have hks super afr
- My friends' EVO with WORKS ECU Flash
- how do YOU get your oil filter off?
- Valve Spring Compressor
- High Flow Cat?
- CORKsport Power series exhaust
- Dilemma: Racing Beat vs. HKS
- OMG Yes another Intake thread...
- Reactive Cold Air Intake
- I need help in a BIG way!!! oil pressure sensor
- Speaking of UDPs.... help
- brake pads
- Engine balancing
- driving me nuts (injen cai)
- Attn: Racing Mazda Header Owners
- Redline Water Wetter
- MSD Ignition Control Unit
- MT-90 is good stuff!!!!
- need help fast...........
- Who's opened up their tranny?
- Need Help With ACT Clutch
- Gas Level Gauge
- burns stainless muffler
- multiposition exhaust hangers?
- msp engine swap?
- where does the air for the stock intake come from?
- MAF waffle?
- Brake decisions
- Ractive Header Arrived
- Tokico Strut and Spring Kit?
- H.P. Needed
- Stock intake mod 56K = DIE!!
- Carbon Hoods!!
- Stop-Tech Brembo etc.
- Suspension Help
- Valve lash....
- AEM Short Ram Mass Airflow Sensor placement?
- Rear Motor Mount Install
- Springs
- clutch choices
- Change brake pads myself?
- EGR bypass
- need to find a shop in CT that installs gauges
- being electricuted sucks
- Considering new radiator.
- is this a good header?
- ATF cooler
- First 2 Mods...
- Wiring a switch for our fans
- Tokico Springs?
- Probe header
- Brembo Rotors on Ebay
- CAI How-to
- EGR bypass
- Supercharger question.
- Anyone w/cutouts or open DP's??
- bypass exhaust?
- Crank? Rod? What do you think?
- Cold Air Intake
- Reduce Drag?
- Fuel Filter.
- Quick intake Question
- How to install a CEL eliminator please!!!
- Megan Exhaust Anyone Have???
- Dyno chart and pics after exhaust
- O2 temp sensor question
- Pulleys
- need help
- is there any way to get CARB approval?
- GREDDY | Speed Limiter Cut Controller Type-A
- Chains instead of motor mounts
- Smallest Driving Lights?
- Horsepower
- how dangerous is redline
- mazdaspeed muffler tip
- Rotors???
- Note: Cross-drilling nor slotting provide any benefits
- x-brace to eliminate wheel hop??
- ? from the new guy...
- Blitz gauges..., Anybody have them?
- De-Carbonization?
- MSP catback vs Racing Beat catback
- Cryotreat Tranny?
- What size resonator should I use?
- Exhaust Help Please?
- Anyone run Lucas disc-style injectors?
- Rods for HIBOOST
- Anyone with sound clips of clutch rattle?
- Downpipe Flange Questions
- Clutch
- Where to mount temp senders for a gauge?
- cylinders
- What Causes Wheel Hop
- cat back exhaust
- ATTN: Cam owners
- Guess Work
- AWR headers/Reliability issues?
- LSD Required for Turbo?
- magnaflow
- my p5 won't start
- Brake Fluid capacity?